Kitchen cabinet refacing in Aliso Viejo is one of the primary factors that homeowners prioritize. One of the well-known types of cupboard renewalis the utilization of veneer. This is an effective variant for sprucing up these kitchen cabinets that have been well-maintained but are starting to show their age. It is less expensive than replacing the entirecupboard set. Despite its budget-friendly cost, the results are still top-notch.
A cabinet refacing company will measure the houseowner’s kitchen, determine how many veneerstheyneed, and order the doors and drawer fronts. A professional installer will then remove the old cabinet doors and drawer fronts and replace them with new ones. They will be the ones to help homeowners to select a thicker veneer. It is not advisable toutilize a thin layer of plywood, particle board, or an MDF (Medium-Density Fiberboard) since they will not hold well over the years. Hence, it would be best for homeowners to have specialist help with a thicker veneer made of real hardwood that meets their budget and necessities. This is much more efficient since it can withstand the wear and tear that refacing can cause over time.
How to Apply the Veneer?
The application process of this material can be easy-peasy. Individuals could do this on their ownbylearning about the step-by-step process of its coating on the following:
- To start the refacing process, homeowners should prepare their face frame by cutting a pressure-sensitive veneer to fit each side of the cabinet stile.
- Apply a small amount of contact cement to the back of the exterior and the face frame. This will allow it to adhere securely to the cabinet frame.
- Next, smooth the top surface of the pressure-sensitive veneer by removing any air bubbles using a small block of wood or a Plexiglass scraper. Householders should guarantee to re-sand the edges to match the original finish.
- Once the installation of the veneeris a success, it is vital to trim the corners on both sides of the cabinet to create a smooth edge. A good rule of thumb is cutting with the veneer’s grain.
Although it is feasible to do a DIY (do-it-yourself) cabinet refacing Riverside veneer project, it is much wiser for a homeowner to ask for professional assistance.
They should also recognize the advantages and disadvantages this material could present in the long run. To learn more, continue reading the infographic below created and designed by Kitchen Cabinet Refacing: